Flock Undercoat Adhesive Glue

All orders are dispatched from our Brisbane distribution centre. Same-day dispatch applies to orders placed prior to 2:00PM (AEST). 

AUSTRALIA

• Standard | 3-7 Business Days
• Express | 1-3 Business Days

__________________________

NEW ZEALAND

• Standard | 15 Business Days
• Express | 5-8 Business Days

__________________________

ALL OTHER COUNTRIES

• Standard | 15 Business Days
• Express | 5-8 Business Days

Note - size guides are strictly estimates. Consumption will different for each applicant. Please don’t hesitate to email us for sizing recommendations.*

250 Milliliters (1 Bottle) - Estimated Coverage 3m²

__________________________

500 Milliliters (2 Bottles) - Estimated Coverage 6m²

__________________________

1 Litre (4 Bottles) - Estimated Coverage 12m²

An in-depth installation guide will be placed inside the Flock Industries Applicator Tool.

⚠️ IMPORTANT: Micro-fibres are harmful to ingest can cause health complications. Ensure appropriate protection is used throughout the entire Flocking process. This includes (but limited to); eyewear, gloves, and a face mask. ⚠️

Ensure the surface of your project is thoroughly prepped and you are working within a concealed environment. Poor preparation or working conditions may hinder the finish of your project. This is not a project you want to rush. Dedicate ample time for a proper preparation and application.

• 1) Pour an consistent serve of self-levelling undercoat adhesive over the surface you wish to Flock.
• 2) Using a brush and/or roller, evenly spread the adhesive over the entirety of the canvas/surface. There should be no-runs or notably thick areas

Note - it is crucial to cover the entire surface area including intricate crevices, nooks and crannies. Failure to do so will result in a visibly patchy finish

Note - depending on the conditions, there is a 10-15 minute application window before the undercoat begins to cure. Do not rush the application, however, be mindful of the exposed adhesive.

• 3) Open the Flock Applicator Tool by separating the inner-tube from the outer-tube & remove the installation guide
• 4) Gently pour 25 grams (half a pouch) of Flock Fibres into the *CLOSED* end of the Applicator Tube before mating the tubes back together

Note - you may notice small clumps/build-ups of micro-fibres. The cap of the Applicator Tool incorporates our smartflock™ filtration-system to prevent larger Flock particles from exiting the tube

Use this time to peruse over your project and working conditions:

Note - be mindful of Flock Fibre consumption and reserve quantities. It is crucial the project is Flocked in one application

• 5) Whilst firmly holding onto the outer-tube, pull the inner-tube in a back and forth motion. For optimal application, apply flock from a 45-90° angle and  approx. 180-200MM away from project surface.
• 6) Generously apply Flock to the entire canvas/project. This includes any crevices, nooks and crannies
• 7) Once Flocked, allow between 18 and 24 hours for the fibres to settle and adhesive to cure. Ensure the canvas is not exposed to direct sunlight or outside particles

Note - do not handle or move the canvas unless absolutely necessary. If required, handle the canvas from un-flocked surface areas. Touching the fibres prior to them curing will hinder the end-result

• 8) Next Day - Gently touch a non-exposed portion of the canvas. If the fibres are still tacky, allow additional time for adhesive to cure
• 9) Once cured, gentle lift the canvas and shake-off any excess surface Flock fibres. DO NOT USE A COMPRESSOR AIR-GUN
• 10) Enjoy (and send us through some photos 😉)!

Should you have any questions regarding applying flock, please reach out to our team prior to beginning.